Driver sr needs updating debian quotes about dating someone new

Posted by / 06-Jan-2019 02:37

[ 20.096565] ACPI: PCI Interrupt Link [AAZA] enabled at IRQ 20 [ 20.096565] ACPI: PCI Interrupt 00:0f.1[B] - IRQ 20 [ 20.096565] PCI: Setting latency timer of device 00:0f.1 to 64 [ 20.137122] hda_codec: Unknown model for AD1988, trying auto-probe from BIOS... Priority:-1 extents:1 across:465844k [ 21.813541] EXT3 FS on hdb1, internal journal [ 22.849894] loop: module loaded [ 26.436756] NET: Registered protocol family 10 [ 26.436756] lo: Disabled Privacy Extensions [ 40.875582] eth0: no IPv6 routers present [ 246.900828] ACPI: PCI interrupt for device 00.0 disabled [ 246.944666] ACPI: PCI interrupt for device 00.0 disabled [ 276.516563] forcedeth: Reverse Engineered n Force ethernet driver. [ 276.516563] ACPI: PCI Interrupt 00.0[A] - IRQ 22 [ 276.516563] PCI: Setting latency timer of device 00.0 to 64 [ 277.125401] forcedeth 00.0: ifname eth0, PHY OUI 0x5043 @ 1, addr 00:1a::a [ 277.125401] forcedeth 00.0: highdma csum vlan pwrctl mgmt timirq gbit lnktim desc-v3 [ 277.125401] ACPI: PCI Interrupt 00.0[A] - IRQ 21 [ 277.125401] PCI: Setting latency timer of device 00.0 to 64 [ 277.301197] eth0: no link during initialization.

[ 277.303362] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 277.800041] forcedeth 00.0: ifname eth1, PHY OUI 0x5043 @ 1, addr 00:1a::b0:eb [ 277.800046] forcedeth 00.0: highdma csum vlan pwrctl mgmt timirq gbit lnktim desc-v3 [ 279.070566] eth0: link up.

[ 279.070566] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 293.673845] eth0: no IPv6 routers present [ 764.772570] uvcvideo: Failed to query (1) UVC control 1 (unit 0) : -110 (exp. [ 783.035638] 3:3:1: cannot set freq 16000 to ep 0x86 [ 885.985548] usb 2-6: new full speed USB device using ohci_hcd and address 3 [ 887.043252] usb 2-6: configuration #1 chosen from 1 choice [ 887.047447] usb 2-6: New USB device found, id Vendor=041e, id Product=401a [ 887.047450] usb 2-6: New USB device strings: Mfr=0, Product=0, Serial Number=0 [ 945.901441] usb 2-6: USB disconnect, address 3 ** Loaded modules: Module Size Used by forcedeth 45072 0 ipv6 235396 20 loop 12748 0 snd_hda_intel 325720 0 snd_pcm_oss 32800 0 snd_mixer_oss 12320 1 snd_pcm_oss snd_usb_audio 70272 0 snd_usb_lib 13440 1 snd_usb_audio uvcvideo 45800 0 snd_rawmidi 18496 1 snd_usb_lib snd_seq_device 6380 1 snd_rawmidi snd_pcm 62660 3 snd_hda_intel,snd_pcm_oss,snd_usb_audio compat_ioctl32 1312 1 uvcvideo snd_hwdep 6212 1 snd_usb_audio videodev 27520 1 uvcvideo snd_timer 17800 1 snd_pcm snd 45636 9 snd_hda_intel,snd_pcm_oss,snd_mixer_oss,snd_usb_audio,snd_rawmidi,snd_seq_device,snd_pcm,snd_hwdep,snd_timer snd_page_alloc 7816 2 snd_hda_intel,snd_pcm v4l1_compat 12260 2 uvcvideo,videodev i2c_nforce2 5536 0 i2c_core 19828 1 i2c_nforce2 button 6096 0 pcspkr 2432 0 soundcore 6368 1 snd evdev 8000 4 ext3 105576 6 1 ext3 mbcache 7108 1 ext3 ide_disk 10496 3 sg 26964 0 sr_mod 13316 0 sd_mod 22200 0 cdrom 30176 1 sr_mod usbhid 35904 4 1 usbhid ff_memless 4392 1 usbhid amd74xx 7752 0 [permanent] ide_pci_generic 3908 0 [permanent] ide_core 96168 3 ide_disk,amd74xx,ide_pci_generic ata_generic 4676 0 sata_nv 19848 0 ohci_hcd 18532 0 libata 140448 2 ata_generic,sata_nv ehci_hcd 28428 0 usbcore 118192 7 snd_usb_audio,snd_usb_lib,uvcvideo,usbhid,ohci_hcd,ehci_hcd scsi_mod 129548 4 sg,sr_mod,sd_mod,libata dock 8304 1 libata thermal 15228 0 processor 32576 1 thermal fan 4196 0 thermal_sys 10856 3 thermal,processor,fan ** PCI devices: .0 Host bridge [0600]: n Vidia Corporation C55 Host Bridge [10de:03a1] (rev a2) Control: I/O- Mem Bus Master Spec Cycle- Mem WINV- VGASnoop- Par Err- Stepping- SERR- Fast B2B- Dis INTx- Status: Cap 66MHz UDF- Fast B2B Par Err- DEVSEL=fast .1 RAM memory [0500]: n Vidia Corporation C55 Memory Controller [10de:03ac] (rev a1) Control: I/O- Mem- Bus Master- Spec Cycle- Mem WINV- VGASnoop- Par Err- Stepping- SERR- Fast B2B- Dis INTx- Status: Cap- 66MHz UDF- Fast B2B- Par Err- DEVSEL=fast Kernel driver in use: pcieport-driver Kernel modules: shpchp .0 PCI bridge [0604]: n Vidia Corporation C55 PCI Express bridge [10de:03b9] (rev a1) (prog-if 00 [Normal decode]) Control: I/O Mem Bus Master Spec Cycle- Mem WINV- VGASnoop- Par Err- Stepping- SERR- Fast B2B- Dis INTx Status: Cap 66MHz- UDF- Fast B2B- Par Err- DEVSEL=fast Kernel driver in use: pcieport-driver Kernel modules: shpchp .0 PCI bridge [0604]: n Vidia Corporation C55 PCI Express bridge [10de:03bb] (rev a1) (prog-if 00 [Normal decode]) Control: I/O Mem Bus Master Spec Cycle- Mem WINV- VGASnoop- Par Err- Stepping- SERR- Fast B2B- Dis INTx Status: Cap 66MHz- UDF- Fast B2B- Par Err- DEVSEL=fast Kernel driver in use: pcieport-driver Kernel modules: shpchp .0 RAM memory [0500]: n Vidia Corporation MCP55 Memory Controller [10de:0369] (rev a1) Subsystem: ASUSTe K Computer Inc.

Device [1043:cb84] Control: I/O- Mem Bus Master Spec Cycle- Mem WINV- VGASnoop- Par Err- Stepping- SERR- Fast B2B- Dis INTx- Status: Cap 66MHz UDF- Fast B2B Par Err- DEVSEL=fast 00:0a.0 ISA bridge [0601]: n Vidia Corporation MCP55 LPC Bridge [10de:0360] (rev a2) Subsystem: ASUSTe K Computer Inc.

Device [1043:cb84] Control: I/O Mem Bus Master Spec Cycle- Mem WINV- VGASnoop- Par Err- Stepping- SERR- Fast B2B- Dis INTx- Status: Cap 66MHz UDF- Fast B2B Par Err- DEVSEL=fast Kernel driver in use: forcedeth Kernel modules: forcedeth .0 Bridge [0680]: n Vidia Corporation MCP55 Ethernet [10de:0373] (rev a2) Subsystem: ASUSTe K Computer Inc.

Any idea why these two distributions are reporting a different size of hard disk?Device [1043:cb84] Control: I/O Mem Bus Master Spec Cycle- Mem WINV- VGASnoop- Par Err- Stepping- SERR- Fast B2B- Dis INTx- Status: Cap 66MHz UDF- Fast B2B Par Err- DEVSEL=fast Kernel driver in use: sata_nv Kernel modules: sata_nv 00:0f.0 PCI bridge [0604]: n Vidia Corporation MCP55 PCI bridge [10de:0370] (rev a2) (prog-if 01 [Subtractive decode]) Control: I/O Mem Bus Master Spec Cycle- Mem WINV- VGASnoop- Par Err- Stepping- SERR Fast B2B- Dis INTx- Status: Cap 66MHz UDF- Fast B2B Par Err- DEVSEL=fast 00:0f.1 Audio device [0403]: n Vidia Corporation MCP55 High Definition Audio [10de:0371] (rev a2) Subsystem: ASUSTe K Computer Inc.Device [10f2] Control: I/O- Mem Bus Master Spec Cycle- Mem WINV- VGASnoop- Par Err- Stepping- SERR- Fast B2B- Dis INTx- Status: Cap 66MHz UDF- Fast B2B Par Err- DEVSEL=fast Kernel driver in use: HDA Intel Kernel modules: snd-hda-intel .0 Bridge [0680]: n Vidia Corporation MCP55 Ethernet [10de:0373] (rev a2) Subsystem: ASUSTe K Computer Inc. I'm a long time Debian and Ubuntu user and just installed Arch Linux a couple weeks ago. I currently dual boot between Arch and Ubuntu 7.10.However, I noticed whenever starting up in Arch, the kernel would complain about one of my partitions.

driver sr needs updating debian-70driver sr needs updating debian-19driver sr needs updating debian-28

Device [1043:cb84] Control: I/O- Mem Bus Master Spec Cycle- Mem WINV- VGASnoop- Par Err- Stepping- SERR- Fast B2B- Dis INTx- Status: Cap 66MHz UDF- Fast B2B Par Err- DEVSEL=fast Kernel driver in use: ehci_hcd Kernel modules: ehci-hcd 00:0d.0 IDE interface [0101]: n Vidia Corporation MCP55 IDE [10de:036e] (rev a1) (prog-if 8a [Master Sec P Pri P]) Subsystem: ASUSTe K Computer Inc.